Fireplace
Fireplace
For your safety READ THE INSTRUCTION BEFORE LIGHTING.
Warning: If, at any time, you smell gas, do not light the furnace or turn it OFF if is already lighted, and call Terasen Gas's 24hr emergency line at 1-800-663-9911 or call 911 if you cannot reach Terasen
Lighting the Furnace - Instructions
1. Open the fireplace panel (just flip it down. no tools necessary)
2. Turn the Gas Control Knob on "PILOT" position. The knob could be turned only if it is slightly pressed.
image 1 - "PILOT" position image 2 - "OFF" position image 3 - "ON" position
3. With the Gas Control Knob on "PILOT" position and pressed, push the Piezzo ignite button (image 4). Keep the Gas Control Knob pressed for about 1 min (the furnace pilot needs to warm up) - image 5.
image 4 - The Piezzo ignite button image 5 - Gas Control Knob pressed
4. Release the Gas Control Knob. The furnace pilot flame should stay on. If not, try steps 2 and 3 again. If still the flame goes off, turn the furnace on OFF position and call a technician. If the flame stays on you can light the furnace from the Remote Switch (a switch on wall close to fireplace).
5. You can adjust the furnace's power by switching the Power Volume button from Low to High.
Friendly Advice: If you don't use the fireplace regularly, turn off the pilot light. This act will reduce the temperature of your apartment by several degrees and we don't do unnecessary waste of money.
OTHER Parts for your Fireplace:
Master Valve - "ON" position Master Valve - "OFF" position The Regulator
The Master Valve allows the gas into fireplace if it is "ON" position and stops the gas if is "OFF" position.
The Regulator adjusts the volume of gas. DO NOT TOUCH THIS UNDER ANY CIRCUMSTANCES.
For better understanding you can find the Instructions inside. If not, you can click on the picture showed below and magnify it.
